Gap for all your pvc u building products.
Gap in upvc french doors.
If your door meets at the top but there is a gap at the bottom then it could just need an adjustment to the hinge to pull it back into shape.
If your door meets at the top and bottom of the frame but not in the middle your door is most likely to be warped and needs replacing.
I had a local company out to take a look who advised as the doors couldn t be adjusted for them to trim down the keep post sorry don t know what its called.
How to fix drafty french doors step 1.
Over time the screws on your hinges may come loose and cause your doors to sag.
Tighten all of the screws in each hinge with a screwdriver.
We take great pride in manufacturing and distributing high quality pvc u building products from our network of over 80 depots in the uk.
Install adhesive weatherstripping foam around the door frame where the french doors touch the frame.
Turn the upper hinge adjustment screw to even out the gap.
Check the distance between the french doors leaf and frame with a tape measure or yard stick.
Long story short they butchered the door which left me with the attached image.
Cheap upvc doors can warp.
Use the type of screwdriver that matches the heads on the hinge screws.
Undo the screw fully reinset the pin and then lock the screw.
Under neath the hinge should be another adjust nut to raise or lower the door by 2mm.
Over time doors can sag on the.
Only remove the pin if you want to remove the door.
There should be another screw in the middle on the hinge to hold this in place.
This adjustment works well if you have a gap between the french doors or the latch mechanism doesn t connect.
In order to adjust it you have to turn the corner bearing adjusting screw.
Gap is also the home of rockdoor the most secure and thermally efficient composite door available.
Sorry for the very late reply didn t get the e mail notification that people had replied to the topic.
Adjust both doors to ensure they are properly aligned with the door frame.
The doors are french doors i think they aren t sliding doors and they are a bit like a standard pvcu front door apart from they are almost fully glass apart from the pvcu border and there are two doors.
Do this on both doors.
Check the seams of the french.
The pin in the hinge should be knocked back in unless its bent.
When i open the french doors there are two metal locating blocks at the base of the doors.
As you can imagine a draft comes though this gap which needs to be eliminated.
I ve some quite old upvc french doors in a bay which over the years started to drop.
Open both of the french doors to expose the screws holding the hinges in place.
