Find the information you are looking for in videos faqs tips and more.
Ge stackable washer dryer lid won t lock.
If there is a pause in the washer cycle the controls will lock up.
The release is normally accessible from below the door lock or on some models from inside the soap dispenser housing.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Ge appliances offers troubleshooting support for washers and dryers.
If the washer was stopped before the cycle was complete.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
If it still won t budge proceed to plan b.
Hi all you guys helped me before.
If the door lock is defective the washer door will not latch properly.
The top dryer is working fine the lower washer does nothing when you close the lid.
To find the correct replacement part.
If your washer is not spinning it could be the lid switch lock.
So at work we have a stacked ge washer dryer.
Nothing in none of the stages.
If the washer fills but won t start the agitation cycle the lid lock switch could be defective.
Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid.
If it opens you re all set.
No water coming out nothing.
Here is how to replace it on a stackable washer dryer.
Door lock motor and switch assembly the door lock secures the washer door shut during operation.
Left and right arrows move across top level links and expand close menus in sub levels.
The pause can occur because of the following.
If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault.
A power failure or if it was put in the test mode at the factory.